Electrified Strikes
The Electrified Strikes class provides the student with the knowledge required in selecting the proper electric strike based on door hardware and frame type. The student will install various electric strikes on wood, aluminum, and steel frames, as well as complete a basic access system. Most manufactures products are covered in detail. This program does not require approval under the Private Career Colleges Act, 2005.
Optional:
- Boring jig (with router)
- Die grinder (with metal cutting blades)
Proof of Clean Criminal Record Check is Required.
Proof of Post Secondary or Equivalent Education Required.
Required Tools
-
Safety glasses -
Extension cord -
Jig saw (with metal cutting blades) -
Drill bits Recommend student have full drill index. (Minimum 1/8, 5/32, 7/32 3/8 and 1/2). -
Electric or cordless drill -
Taps with proper drill size for 8-32NC w/#29 drill, 10-24NC w/#25 drill, 10-32NC w#21 drill, 12- 24N -
Try square or combination square. -
Centre punch -
Vise grips -
Flat file 10" or 12" (bastard or 2nd cut) -
Round 1/4" x 10" (bastard or 2nd cut) -
1/4 - 20 tap -
Multimeter (digital preferred) -
at least 6 course and 6 fine jigsaw blades -
Tap wrench -
Basic hand tools, (slot, Philips, Robertson) screw drivers, hammer, Allen/hex head key set (fraction -
Safety glasses as well as safety boots or shoes are mandatory
